Normally, you should get a spindle water cooling pump together with a water tank.

Step 1. Please put the spindle water pump in the water tank.

Step 2. Please inject clean water into the water tank. How much water needs to be injected? CNC spindle water cooling pump must be fully immersed in water, the height of water should be 2 times of height of submersible water pump.

Step 3. Please connect the inlet hose of the water cooled spindle motor to the submersible water pump and put the outlet hose in the water tank. This forms a water circulation. Please refer to the following schematic diagram.

Step 4. Turn on the cnc spindle water cooling pump, and the water circulation cooling system starts working.

To order the product, please click cnc spindle water cooling pump

Some important tips for using cnc spindle water cooled pumps

Tip 1. Before using the pump, please make sure the rated voltage marked on the nameplate and the voltage of actual use is consistent.

Tip 2. When installing, removing and cleaning the pump, you must unplug the power plug to ensure safety.

Tip 3. The filter canister and foam must be cleaned timely, so as to get normal water inlet and best filter.

Tip 4. If the cnc spindle water cooling pump has been a serious collision, please check the pump, if damage, please stop use immediately.

                                                       Original article from Jinan EagleTec CNC Machinery Co.,Ltd.

                                                       Repost please indicate the source.